Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL REAR DOOR BELT MOULDING


    B087554E02
  1. Engage the 6 claws and install a new front door belt molding.



2. INSTALL REAR DOOR TRIM PANEL ASSEMBLY


B088073E01
  1. Engage the 9 clips and install the rear door trim panel assembly LH.

  1. Install the door assist grip assembly LH with the screw.



3. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY


    B088070
  1. Connect the connector.



    B088069E01
  1. Engage the 2 claws and install the rear power window regulator switch assembly.



4. INSTALL REAR DOOR FRAME GARNISH


B088415E01
  1. Engage the 4 clips and install the rear door frame garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel before the garnish is installed. Transfer any remaining clips to the garnish side before installing it. Installing the garnish with any clips remaining on the door panel side could cause the clips to drop inside the door panel.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }