Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B087510E02
  1. Apply protective tape to the outer circumference of the roof drip side finish moulding, as shown in the illustration.

  1. Using a heat light, heat the roof drip side finish moulding.

    Heating temperature:
    40 to 60°C (104 to 140°F )

    NOTICE:
    Do not heat the roof drip side finish moulding and vehicle body excessively.

  1. Using a moulding remover, disengage the 2 clips and remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips from the vehicle body.
    2. If the clips are damaged or removed accidentally, replace them.