Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Separate Folding Seat Type)

FRONT SEAT ASSEMBLY (for Separate Folding Seat Type) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. INSTALL FRONT SEAT ASSEMBLY


    B087346E01
  1. Place the front seat in the cabin.

  1. Tighten the 2 bolts on the front side of the front seat.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }

  1. Tighten the 2 bolts on the rear side of the front seat.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B087647E01
  1. Install the wire harness clamp.

  1. Connect the connector.

  1. Connect the airbag connector.



2. INSTALL SEAT TRACK COVER


B087345E01

HINT:
Follow the same procedures as for the opposite side.

  1. Engage the 2 claws and install the seat track cover.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSPECT SRS WARNING LIGHT
(Click here)