Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Separate Folding Seat Type)

FRONT SEAT ASSEMBLY (for Separate Folding Seat Type) > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


2. REMOVE SEAT TRACK COVER


B087345E01

HINT:
Follow the same procedures as for the opposite side.

  1. Disengage the 2 claws and remove the seat track cover.



3. REMOVE FRONT SEAT ASSEMBLY


    B087647E01
  1. Disconnect the connector.

  1. Disconnect the airbag connector.

  1. Using a clip remover, remove the wire harness clamp.



    B087346E01
  1. Remove the 4 bolts and front seat.