DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL (for 4WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEELS |
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 4 bolts and No. 1 engine under cover sub-assembly.
| 4. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Engine Under Cover No, 2) |
Remove the 4 bolts and No. 2 engine under cover sub-assembly.
| 5. DRAIN DIFFERENTIAL OIL |
| 6. REMOVE FRONT AXLE SHAFT LH NUT |
![]() |
Using a screwdriver and a hammer, remove the front axle hub grease cap.
![]() |
Remove the cotter pin and adjusting cap.
Remove the front axle hub nut.
| 7. REMOVE FRONT AXLE SHAFT RH NUT |
| 8. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH |
![]() |
Remove the 2 nuts and front stabilizer link LH.
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH |
| 10. SEPARATE FRONT SPEED SENSOR LH |
![]() |
Remove the bolt and separate the front speed sensor.
Disengage the 2 clamps.
Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
| 11. SEPARATE FRONT SPEED SENSOR RH |
| 12. SEPARATE TIE ROD END SUB-ASSEMBLY LH |
Remove the cotter pin and nut.
![]() |
Using SST, separate the tie rod end from the steering knuckle arm.
| 13. SEPARATE TIE ROD END SUB-ASSEMBLY RH |
| 14. SEPARATE FRONT SUSPENSION LOWER ARM LH |
![]() |
Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.
| 15. SEPARATE FRONT SUSPENSION LOWER ARM RH |
| 16. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
![]() |
Using SST, remove the front drive shaft.
| 17. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
| 18. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
![]() |
Using SST, remove the oil seal.