DIFFERENTIAL CARRIER OIL SEAL > REMOVAL |
| 1. DRAIN DIFFERENTIAL OIL |
| 2. REMOVE PROPELLER SHAFT ASSEMBLY (for 2WD Regular Cab) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.
![]() |
Remove the propeller shaft.
Insert SST into the transmission to prevent oil leakage.
| 3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 2WD Except Regular Cab) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts and 4 washers, and remove the propeller shaft.
![]() |
Remove the 2 center support bearing bolts from the frame crossmember.
![]() |
Pull out the propeller shaft.
Insert SST into the transmission to prevent oil leakage.
| 4. REMOVE PROPELLER SHAFT ASSEMBLY (for 4WD Regular Cab) |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft.
| 5. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD Except Regular Cab) |
![]() |
Place matchmarks on the propeller shaft flange and differential.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.
![]() |
Remove the 2 center support bearing bolts from the frame crossmember.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft.
| 6. REMOVE REAR DRIVE PINION NUT |
![]() |
Using SST and a hammer, unstake the nut.
![]() |
Using SST to hold the companion flange, remove the nut.
| 7. REMOVE REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY REAR |
![]() |
Using SST, remove the companion flange.
| 8. REMOVE REAR DIFFERENTIAL CARRIER OIL SEAL |
![]() |
Using SST, remove the oil seal.
| 9. REMOVE REAR DIFFERENTIAL DRIVE PINION OIL SLINGER (w/ Differential Lock) |
| 10. REMOVE REAR DRIVE PINION FRONT TAPERED ROLLER BEARING |
![]() |
Using SST, remove the front bearing.
Using SST, remove the front bearing outer race.
Using a screwdriver, bend the oil storage ring and remove it.
| 11. REMOVE REAR DIFFERENTIAL DRIVE PINION BEARING SPACER |