Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER (for 4WD and Pre-Runner)

FRONT SHOCK ABSORBER (for 4WD and Pre-Runner) > DISPOSAL

for Preparation Click here



1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT


F052444E01
  1. Fully extend the shock absorber piston rod, and fix it at an angle in a vise or similar tool.

  1. Using a drill or similar tool, slowly make a hole in the shaded area shown in the illustration, and discharge the gas inside.

    CAUTION:
    1. The gas is colorless, odorless and harmless.
    2. Since the discharged gas may cause chips to scatter, cover the drill with a shop rag when making the hole.