Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER (for 4WD and Pre-Runner)

FRONT SHOCK ABSORBER (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO. 1


3. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


C099158
  1. Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



4. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



5. REMOVE FRONT STABILIZER BRACKET NO. 1 LH


G020162
  1. Remove the 2 bolts and front stabilizer bracket.



6. REMOVE FRONT STABILIZER BRACKET NO. 1 RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



7. REMOVE FRONT STABILIZER BAR


8. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F051679E02
  1. Using SST, separate the tie rod end from the steering knuckle arm.

    SST
    09628-62011  



9. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


C099159
  1. Remove the bolt, nut and washer.



    C099160
  1. Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.