Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER (for 4WD and Pre-Runner)

FRONT SHOCK ABSORBER (for 4WD and Pre-Runner) > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT COIL SPRING


C099165E01
  1. Using SST, compress the front coil spring.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  

    NOTICE:
    Do not use an impact wrench. It will damage SST.

  1. Install the front coil spring onto the shock absorber front.

    HINT:
    Fit the lower end of the front coil spring into the gap of the spring lower seat.



2. INSTALL FRONT SHOCK ABSORBER CUSHION RETAINER


3. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY


4. INSTALL FRONT SHOCK ABSORBER CUSHION NO. 1


5. INSTALL FRONT SHOCK ABSORBER CUSHION RETAINER


6. INSTALL FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


F052437E01
  1. Align the suspension support and the absorber bush as shown in the illustration.

  1. Fit and tighten a new lock nut.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.

  1. Release the coil spring while checking the position of the suspension support.