FRONT UPPER SUSPENSION ARM (for 2WD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEEL |
| 3. INSPECT FRONT SUSPENSION UPPER ARM |
Check that there is no slack on the ball joint by shaking the upper arm up and down by hand.
| 4. SEPARATE SKID CONTROL SENSOR WIRE |
![]() |
Remove the speed sensor connector.
Remove the 2 bolts, and separate the skid control sensor wire.
| 5. SEPARATE FRONT FLEXIBLE HOSE |
![]() |
Remove the bolt, and separate the front flexible hose.
| 6. REMOVE FRONT SUSPENSION UPPER ARM |
![]() |
Support the front suspension lower arm with a jack.
Remove the clip and nut.
Using SST, separate the upper ball joint from the steering knuckle.
![]() |
Remove the 2 bolts.
Remove the front suspension upper arm.