FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) > INSTALLATION |
| 1. TEMPORARILY TIGHTEN FRONT SUSPENSION UPPER ARM |
![]() |
Install the front suspension upper arm, and temporarily tighten the bolt, 2 washers and nut.
![]() |
Install the bracket with the bolt.
![]() |
Install a new nut and a new clip.
| 2. INSTALL SKID CONTROL SENSOR WIRE |
![]() |
Install the skid control sensor wire with the 2 bolts.
| 3. INSTALL FRONT WHEEL |
| 4. STABILIZE SUSPENSION |
Jack down the vehicle.
Bounce the vehicle up and down several times to stabilize the suspension.
| 5. FULLY TIGHTEN FRONT SUSPENSION UPPER ARM |
![]() |
Fully tighten the nut.
| 6. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |