Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner)

FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SUSPENSION UPPER ARM


G020170
  1. Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf } or less

  1. Check for any cracks and grease leakage on the ball joint dust cover.