Home › SUSPENSION & AXLE › SUSPENSION › FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner)

FRONT UPPER SUSPENSION ARM (for 4WD and Pre-Runner) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. INSPECT FRONT SUSPENSION UPPER ARM
  1. Check that there is no slack on the ball joint by shaking the upper arm up and down by hand.



3. SEPARATE SKID CONTROL SENSOR WIRE


C099168
  1. Remove the 2 bolts, and separate the skid control sensor wire.



4. REMOVE FRONT SUSPENSION UPPER ARM


G020151E01
  1. Support the front suspension lower arm LH with a jack.

  1. Remove the clip and nut.

  1. Using SST, separate the upper ball joint from the steering knuckle.

    SST
    09628-62011  



    G020152
  1. Remove the bolt and bracket.



    G020153
  1. Remove the bolt, 2 washers and nut.

  1. Remove the front suspension upper arm.