Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM (for 2WD)

FRONT LOWER SUSPENSION ARM (for 2WD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. INSPECT FRONT SUSPENSION LOWER ARM


F051495
  1. Install the hub nuts onto the disc.

  1. Using a dial indicator, check the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf).

    Maximum:
    0.5 mm (0.020 in.)

    HINT:
    If it is not within the specification, replace the lower arm.



3. REMOVE FRONT STABILIZER LINK ASSEMBLY


F051485
  1. Remove the 2 nuts, 2 retainers, 2 cushions and the front stabilizer link LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



4. SEPARATE FRONT SHOCK ABSORBER WITH COIL SPRING


F051496
  1. Remove the bolt, nut and washer.

  1. Separate the front shock absorber with coil spring from the suspension lower arm.



5. REMOVE FRONT SUSPENSION LOWER ARM


F051497
  1. Remove the 2 bolts, and separate the front lower ball joint attachment from the front axle.



    F051498E01
  1. Place matchmarks on the camber adjust cam No. 2.

  1. Remove the 2 nuts, 2 No. 2 camber adjust cams, 2 No. 1 camber adjust cams and front suspension lower arm.



    F051500E01
  1. Remove the cotter pin and nut.

  1. Using SST, remove the front lower ball joint attachment.

    SST
    09628-00011  



6. REMOVE FRONT SPRING BUMPER


F051499
  1. Remove the front spring bumper.