Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM (for 4WD and Pre-Runner)

FRONT LOWER SUSPENSION ARM (for 4WD and Pre-Runner) > INSPECTION

for Preparation Click here



1. INSPECT FRONT SUSPENSION LOWER ARM


G021680
  1. Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } or less

  1. Check for any cracks and grease leakage on the ball joint dust cover.