FRONT LOWER SUSPENSION ARM (for 4WD and Pre-Runner) > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. INSPECT FRONT SUSPENSION LOWER ARM |
![]() |
Install the hub nuts onto the disc.
Using a dial indicator, check the lower ball joint for excessive play when you push the hub nuts up and down with a force of 294 N (30 kgf, 66 lbf).
| 3. SEPARATE FRONT SHOCK ABSORBER WITH COIL SPRING |
![]() |
Remove the bolt, nut and washer.
Separate the front shock absorber with coil spring from the suspension lower arm.
| 4. REMOVE FRONT SUSPENSION LOWER ARM |
![]() |
Remove the 2 bolts, and separate the front lower ball joint attachment from the front axle.
![]() |
Place matchmarks on the camber adjust cam No. 2 and toe adjust cam.
Remove the nut, camber adjust cam No. 2, camber adjust cam No. 1, bolt, toe adjust cam, toe adjust plate No. 2 and front suspension lower arm.
![]() |
Remove the cotter pin and the nut.
Using SST, remove the front lower ball joint attachment LH.