Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR (for 2WD)

FRONT STABILIZER BAR (for 2WD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEELS


2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


F051485
  1. Remove the 2 nuts, 2 retainers, 2 cushions and the front stabilizer link LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



4. REMOVE FRONT STABILIZER BRACKET NO. 1 LH


F051486
  1. Remove the 2 bolts and front stabilizer bracket.



5. REMOVE FRONT STABILIZER BRACKET NO. 1 RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



6. REMOVE FRONT STABILIZER LOWER BRACKET BUSH LH


7. REMOVE FRONT STABILIZER LOWER BRACKET BUSH RH


8. REMOVE FRONT STABILIZER BAR