Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR (for 4WD and Pre-Runner)

FRONT STABILIZER BAR (for 4WD and Pre-Runner) > INSPECTION

for Preparation Click here



1. INSPECT FRONT STABILIZER LINK ASSEMBLY


G021679
  1. Flip the ball joint stud back and forth 5 times, as shown in the illustration, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf } or less

  1. Check for any cracks and grease leakage on the ball joint dust cover.