Home › SUSPENSION & AXLE › SUSPENSION › REAR STABILIZER BAR (for Sport Suspension Package)

REAR STABILIZER BAR (for Sport Suspension Package) > INSPECTION

for Preparation Click here



1. INSPECT REAR STABILIZER LINK ASSEMBLY


D028478
  1. Flip the ball joint back and forth 5 times, as shown in the illustration, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn, and take the torque reading on the 5th turn.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf } or less

  1. Check for any cracks and grease leakage on the ball joint dust cover.