TRANSFER CASE OIL SEAL > REMOVAL |
| 1. DRAIN TRANSFER OIL |
| 2. REMOVE EXHAUST FRONT PIPE ASSEMBLY NO. 2 (for 1GR-FE) |
Remove the 2 bolts and 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust front pipe.
Remove the 2 nuts, then separate the exhaust front pipe No. 2 from the exhaust manifold LH.
Separate the insulator, then remove the exhaust front pipe No. 2.
| 3. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY (for 1GR-FE) |
![]() |
Remove the 2 bolts and propeller shaft heat insulator bracket.
| 4. REMOVE PROPELLER SHAFT ASSEMBLY FRONT |
![]() |
Place matchmarks on the propeller shaft flange and differential flange.
Remove the 4 nuts, 4 bolts, 4 washers and front propeller shaft.
![]() |
Place matchmarks on the propeller shaft flange and transfer flange.
Remove the 4 nuts, 4 washers and front propeller shaft.
| 5. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY |
![]() |
Using a chisel and hammer, loosen the staked part of the output shaft companion flange lock nut.
Using SST to hold the output shaft companion flange, remove the output shaft companion flange lock nut.
![]() |
Using SST, remove the output shaft companion flange sub-assembly (front side).
| 6. REMOVE TRANSFER CASE OIL SEAL |
![]() |
Using SST, remove the oil seal.