Home › DRIVE LINE › VF2BM TRANSFER › EXTENSION HOUSING OIL SEAL

EXTENSION HOUSING OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL


F043486E02
  1. Coat the lip of a new oil seal with MP grease.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.

    SST
    09223-46011  
    09631-32020  



2. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Using SST, install the companion flange sub-assembly using the same procedure as for the companion flange sub-assembly (rear side).

    SST
    09330-00021  



3. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Except Regular Cab)


C098709E02
  1. Align the matchmarks on the yoke and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    C098708E02
  1. Align the matchmarks on the yoke and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    D033899E01
  1. Provisionally install the center support bearing with 2 mounting bolts.

    HINT:
    Make sure the bearing is installed with the drain hole facing downwards.

  1. Torque the 2 bolts.

    Torque:
    36 N*m{ 369 kgf*cm , 27 ft.*lbf }



4. INSTALL PROPELLER SHAFT ASSEMBLY (for Regular Cab)


C098709E02
  1. Align the matchmarks on the yoke and transfer flange.

  1. Install the propeller shaft with the 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



    C060588E01
  1. Align the matchmarks on the yoke and differential flange.

  1. Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.

    Torque:
    88 N*m{ 899 kgf*cm , 65 ft.*lbf }



5. ADD TRANSFER OIL


6. INSPECT TRANSFER OIL


C083746E02
  1. Remove the filler plug and gasket.

  1. Check that the oil level is within 5 mm (0.20 in.) of the bottom of the filler plug hole.

    NOTICE:
    1. When replacing the oil, recheck the oil level after driving.
    2. Excessively large or small quantities of oil may cause troubles.

  1. When the oil level is too low, check for oil leakage.

  1. Tighten the filler plug with a new gasket.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



7. CHECK FOR TRANSFER OIL LEAKAGE