PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Apply the parking brake and turn the ignition switch to ON.
Depress the brake pedal and check that the engine starts only when the shift lever is set in N or P and that it does not start in any other positions.
Check that the back-up light comes on only when the shift lever is set in R and not in other positions.
If any failure is found, check the park/neutral position switch for continuity.
| 2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Loosen the bolt of the park/neutral position switch and set the shift lever to N.
Align the groove and the neutral basic line.
| *a | Groove |
| *b | Neutral Basic Line |
Hold the switch in position and tighten the bolt.
After making an adjustment, perform the inspection described in step 1.