Home › TRANSMISSION ยท A340F AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Install the park/neutral position switch onto the manual valve lever shaft and provisionally tighten the adjusting bolt.

  1. Install the grommet, a lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }



    C213714E03
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
    Text in Illustration 
    *a
    N Position
    *b
    P Position
    *c
    R Position



    D025795E23
  1. Align the neutral basic line with the switch groove and tighten the adjusting bolt.
    Text in Illustration 
    *a
    Groove
    *b
    Neutral Basic Line

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Bend the tabs of the lock washer.

    HINT:
    Bend at least 2 of the lock washer tabs.



2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR


3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking brake and turn the ignition switch to ON.

  1. Depress the brake pedal and check that the engine starts only when the shift lever is set in N or P and that it does not start in any other positions.

  1. Check that the back-up light comes on only when the shift lever is set in R and not in other positions.
    If any failure is found, check the park/neutral position switch for continuity.



4. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


D025795E23
  1. Loosen the bolt of the park/neutral position switch and set the shift lever to N.

  1. Align the groove and the neutral basic line.
    Text in Illustration 
    *a
    Groove
    *b
    Neutral Basic Line

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. After making an adjustment, perform the inspection described in step 1.



5. ADJUST SHIFT LEVER POSITION


    F050822
  1. Remove the nut and clip, and disconnect the transmission control cable assembly from the automatic transmission.



    C213714E03
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
    Text in Illustration 
    *a
    N Position
    *b
    P Position
    *c
    R Position

  1. Connect the transmission control cable assembly to the transmission control cable bracket with a new clip, and connect the cable end to the control shaft lever with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



6. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from P to R, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from N to D and moves rearward when shifting the lever to R.