Home › TRANSMISSION ยท A340F AUTOMATIC TRANSMISSION › ATF TEMPERATURE SENSOR

ATF TEMPERATURE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL TEMPERATURE SENSOR
  1. Coat a new O-ring with Toyota Genuine ATF Type T-IV or equivalent and install it onto the temperature sensor.

  1. Install the temperature sensor.

    Torque:
    15 N*m{ 150 kgf*cm , 11 ft.*lbf }

  1. Connect the temperature sensor connector.



2. CONNECT NO. 1 OIL COOLER INLET TUBE
  1. Provisionally install the No. 1 oil cooler inlet tube.

  1. Provisionally install the No. 1 oil cooler outlet tube.



    C227724E01
  1. Install the 3 clamps and 3 bolts.

    Torque:
    Bolt A:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }
    Bolt B:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



    C226905
  1. Using a union nut wrench, tighten No. 1 the oil cooler inlet tube.

    Torque:
    34 N*m{ 347 kgf*cm , 25 ft.*lbf }

    HINT:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).



3. INSPECT AUTOMATIC TRANSMISSION FLUID

HINT:
  1. Drive the vehicle so that the engine and transmission are at the normal operating temperature.

    Standard ATF temperature:
    70 to 80°C (158 to 176°F)

  2. The ATF temperature can be checked with the Techstream.
    Enter the following menus: Powertrain / Engine and ECT / Data List / A/T Oil Temperature 3.

  1. Park the vehicle on a level surface and set the parking brake.

  1. With the engine idling and the brake pedal depressed, move the shift lever into all positions from P to L. Then return it to P.

  1. Pull out the dipstick and wipe it clean.

  1. Push it back fully into the pipe.



    G036408E02
  1. Pull it out and check that the fluid level is in the HOT range.
    Text in Illustration 
    *a
    OK
    *b
    Add
    If the level is not in the HOT range, add transmission fluid.



4. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK