Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › VALVE BODY ASSEMBLY

VALVE BODY ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
When working with seal packing material, you must observe the following guidelines.

  1. Using a razor blade and gasket scraper, remove all the old seal packing material from the gasket surfaces.
  2. Thoroughly clean all components to remove all loose material.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply seal packing in an approximately 1 mm (0.04 in.) wide bead along the sealing surface.
  5. Parts must be assembled within 10 minutes of application.
    Otherwise, the seal packing material must be removed and reapplied.


1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


F050819
  1. Remove the 2 bolts and oil filler tube.



3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


D028705

NOTICE:
Some fluid will remain in the oil pan.

  1. Remove the 19 bolts and oil pan sub-assembly.



    Q007487E04
  1. Insert the blade of oil pan seal cutter between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.



    AT00103
  1. Examine the particles in the pan.

    1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.
      Steel (magnetic) ... bearing, gear and clutch plate wear
      Brass (non-magnetic) ... bushing wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


D028706
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.

  1. Remove the 5 gaskets from the oil strainer.



5. REMOVE TRANSMISSION WIRE


D029778E03
  1. Disconnect the 4 connectors from each shift solenoid valve.



    AT05066
  1. Remove the bolt and the stopper plate from the case.

  1. Pull the solenoid wiring out of the transmission case.

  1. Remove the O-ring from the solenoid wiring.



6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY


D029011
  1. Remove the 20 bolts and valve body assembly.



    F051845E01
  1. Remove the bolt and shift solenoid valves S1 and S2.

  1. Remove the bolt and shift solenoid valve SLU.

  1. Remove the bolt and shift solenoid valve SLT.