TRANSMISSION WIRE > INSTALLATION |
| 1. INSTALL TRANSMISSION WIRE |
Coat a new O-ring with Toyota Genuine ATF Type T-IV or equivalent, and install it onto the transmission wire.
Install the transmission wire onto the case, and install the stopper plate.
![]() |
Connect the connectors to each shift solenoid valve.
| *a | White |
| *b | Black |
| *c | Orange/Green |
| *d | Yellow/Brown |
Connect the temperature sensor with temperature sensor clamp and the bolt.
| 2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
![]() |
Install 3 new gaskets.
| *1 | Gasket |
![]() |
Install the oil strainer with the 4 bolts.
| 3. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
Remove any packing material and be careful not to drop oil on the contact surfaces of the transmission case and oil pan sub-assembly.
![]() |
Install the 3 magnets onto the oil pan sub-assembly, in the portions indicated in the illustration.
| *1 | Magnet |
![]() |
Apply seal packing to the oil pan as shown in the illustration.
Install the oil pan sub-assembly with the 19 bolts.
| 4. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
Coat a new O-ring with Toyota Genuine ATF Type T-IV or equivalent and install it onto the oil filler tube.
Install the oil filler tube with the 2 bolts.
| 5. ADD AUTOMATIC TRANSMISSION FLUID |
| 6. INSPECT AUTOMATIC TRANSMISSION FLUID |
Park the vehicle on a level surface and set the parking brake.
With the engine idling and the brake pedal depressed, move the shift lever into all positions from P to L. Then return it to P.
Pull out the dipstick and wipe it clean.
Push it back fully into the pipe.
![]() |
Pull it out and check that the fluid level is in the HOT range.
| *a | OK |
| *b | Add |
| 7. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK |