Home › TRANSMISSION ยท A340F AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here


NOTICE:
When working with seal packing material, you must observe the following guidelines.
  1. Using a razor blade and gasket scraper, remove all the old seal packing material from the gasket surfaces.
  2. Thoroughly clean all components to remove all loose material.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply seal packing in an approximately 1 mm (0.04 in.) wide bead along the sealing surface.
  5. Parts must be assembled within 10 minutes of application. Otherwise, the seal packing material must be removed and reapplied.



1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY


F050819
  1. Remove the 2 bolts and oil filler tube.



3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


C212456
  1. Remove the 19 bolts and oil pan sub-assembly.

    NOTICE:
    Some fluid will remain in the oil pan.



    Q007487E04
  1. Insert the blade of oil pan seal cutter between the transmission case and oil pan, cut off applied sealer and remove the oil pan.

    NOTICE:
    When removing the oil pan, be careful not to damage the oil pan flange.



    AT00103
  1. Examine the particles in the pan.

    1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

      Steel (magnetic):
      Bearing, gear and clutch plate wear

      Brass (non-magnetic):
      Bushing wear



4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


D028706
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.

  1. Remove the 3 gaskets from the oil strainer.



5. REMOVE TRANSMISSION WIRE


C212457
  1. Remove the bolt and temperature sensor clamp, and disconnect the temperature sensor.

  1. Disconnect the 4 connectors from each shift solenoid valve.



    AT05066E05
  1. Remove the bolt and the stopper plate from the case.

  1. Pull the solenoid wiring out of the transmission case.

  1. Remove the O-ring from the transmission wire.