EXTENSION HOUSING REAR OIL SEAL > INSTALLATION |
| 1. INSTALL AUTOMATIC TRANSMISSION EXTENSION HOUSING OIL SEAL |
![]() |
Coat the oil seal lip with MP grease.
Using SST and a hammer, carefully tap a new oil seal in until it is flush with the automatic transmission extension housing oil seal.
| 2. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for Except Regular Cab) |
![]() |
Remove SST from the extension housing.
Install the propeller shaft into the extension housing.
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft with the 4 bolts, 4 nuts and 4 washers.
![]() |
Provisionally install the center support bearing with the 2 mounting bolts.
![]() |
Adjust the center support bearing.
Torque the 2 bolts.
| 3. INSTALL PROPELLER SHAFT ASSEMBLY (for Regular Cab) |
![]() |
Remove SST from the extension housing.
Install the propeller shaft assembly into the extension housing.
![]() |
Align the matchmarks on the propeller shaft flange and differential flange.
Install the propeller shaft assembly with the 4 bolts, 4 nuts and 4 washers.
| 4. ADD AUTOMATIC TRANSMISSION FLUID |
| 5. INSPECT AUTOMATIC TRANSMISSION FLUID |
![]() |
Park the vehicle on a level surface and engage the parking brake.
With the engine idling and the brake pedal depressed, shift the shift lever into all positions from P to L, and then return it to the P position.
Pull out the oil level gage and wipe it clean.
Push it back fully into the pipe.
Pull it out and check that the fluid level is within the HOT range.
If there is any leakage, repair or replace O-rings, seal packings, oil seals, plugs or other parts.