Home › TRANSMISSION · A340F AUTOMATIC TRANSMISSION › SHIFT LOCK SYSTEM

SHIFT LOCK SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK SHIFT LOCK OPERATION
  1. Shift the shift lever to the P.

  1. Turn the ignition switch to LOCK.

  1. Check that the shift lever cannot be shifted to any positions other than P.

  1. Turn the ignition switch to ON, depress the brake pedal, and check that the shift lever can be shifted to other positions.



2. CHECK SHIFT LOCK RELEASE LINK OPERATION
  1. Using a small screwdriver, remove the shift lever cap.

  1. When operating the shift lever with the shift lock release link pressed, check that the lever can be shifted to any positions other than P.



3. CHECK KEY INTERLOCK OPERATION
  1. Turn the ignition switch to ON.

  1. Depress the brake pedal and shift the shift lever to any positions other than P.

  1. Check that the ignition key cannot be turned to LOCK.

  1. Shift the shift lever to the P, turn the ignition key to LOCK, and check that the ignition key can be removed.



4. INSPECT SHIFT LOCK CONTROL ECU SUB-ASSEMBLY


F042943E02
  1. Measure the voltage according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component with harness connected
    (Shift Lock Control ECU)

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    12 (KLS+) - 8 (E)
    Ignition switch ACC and P position
    0 V
    Ignition switch ACC and except P position
    7.5 to 11 V
    Ignition switch ACC and except P position (After approximately 1 second)
    6 to 9 V
    6 (ACC) - 8 (E)
    Ignition switch ON
    11 to 14 V
    Ignition switch ACC
    11 to 14 V
    Ignition switch off
    0 V
    7 (STP) - 8 (E)
    Depress brake pedal
    11 to 14 V
    Release brake pedal
    0 V
    1 (IG) - 8 (E)
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    0 V

  1. Measure the resistance according to the value(s) in the table below.

    HINT:
    Do not disconnect the shift lock control ECU connector.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    8 (E) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, replace the shift lock control ECU sub-assembly.



5. INSPECT KEY INTER LOCK SOLENOID


D025589E01
  1. Disconnect the solenoid connector.

  1. Connect KLS+ (4) terminal to the battery positive (+) terminal, and KLS- (3) terminal to the battery negative (-) terminal, and apply about 12 V between KLS+ and KLS- terminals.
    Check that operation noise can be heard from the solenoid.
    If the solenoid does not operate, replace the solenoid.