FLOOR SHIFT ASSEMBLY > ADJUSTMENT |
| 1. INSPECT SHIFT LEVER POSITION |
Check that the shift lever moves smoothly and appropriately from P to R, only when the ignition switch is turned to ON and the brake pedal is depressed.
When starting the engine, make sure that the vehicle moves forward when shifting the lever from N to D and moves rearward when shifting the lever to R.
| 2. ADJUST SHIFT LEVER POSITION |
![]() |
Remove the nut and clip, and disconnect the transmission control cable assembly from the automatic transmission.
![]() |
Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
| *a | N Position |
| *b | P Position |
| *c | R Position |
Connect the transmission control cable assembly to the transmission control cable bracket with a new clip, and connect the cable end to the control shaft lever with the nut.