Home › TRANSMISSION ยท A340F AUTOMATIC TRANSMISSION › FLOOR SHIFT ASSEMBLY

FLOOR SHIFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT ASSEMBLY


C228903
  1. Install the floor shift with the 4 bolts. Tighten the bolts in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the 2 clamps and 2 connectors.



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Connect the transmission control cable with the clip to floor shift assembly.

  1. Install the transmission control cable onto the floor shift assembly.



3. INSTALL FRONT CONSOLE BOX
  1. Engage the 2 clips and claw, and install the front console box.

  1. Install the 2 screws <F>.



4. INSTALL INSTRUMENT PANEL CUP HOLDER TRAY
  1. Engage the 2 clips and 4 claws, and install the instrument panel cup holder tray.

  1. Install the 2 instrument panel cup holders.



5. INSTALL REAR CONSOLE BOX ASSEMBLY


    B290408
  1. Engage the 4 claws and install the console box rear.

  1. Install the 2 screws <F> and 2 bolts <B>.

  1. Install the console box carpet.



6. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B290409
  1. Engage the 6 clips and claw, and install the console upper rear panel.

  1. Install the shift knob.



7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Install the shift lever knob onto the shift lever.



8. ADJUST SHIFT LEVER POSITION


    F050822
  1. Remove the nut and clip, and disconnect the transmission control cable assembly from the automatic transmission.



    C213714E03
  1. Turn the control shaft lever clockwise until it stops, and then turn it counterclockwise 2 notches to set it to the N position.
    Text in Illustration 
    *a
    N Position
    *b
    P Position
    *c
    R Position

  1. Connect the transmission control cable assembly to the transmission control cable bracket with a new clip, and connect the cable end to the control shaft lever with the nut.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



9. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from P to R, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from N to D and moves rearward when shifting the lever to R.