Home › TRANSMISSION ยท A340E AUTOMATIC TRANSMISSION › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Separate Seat Type)


    B290397
  1. Remove the shift knob.

  1. Disengage the 6 clips and claw, and remove the console upper rear panel sub-assembly.



2. REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Seat Type)


    B290398
  1. Remove the console box carpet.



    B290399
  1. Remove the 2 screws <F> and 2 bolts <B>.

  1. Disengage the 4 claws and remove the rear console box assembly.



3. REMOVE INSTRUMENT PANEL CUP HOLDER TRAY (for Separate Seat Type)


    B290400
  1. Remove the 2 instrument panel cup holders.



    B290401
  1. Disengage the 2 clips and 4 claws, and remove the instrument panel cup holder tray.



4. REMOVE FRONT CONSOLE BOX (for Separate Seat Type)


    E232344
  1. Remove the 2 screws <F>.

  1. Disengage the 2 clips and claw, and remove the front console box.



5. REMOVE FRONT CONSOLE BOX (for Bench Seat Type)


    B290402
  1. Remove the shift knob.

  1. Remove the box bottom mat.

  1. Remove the 2 instrument panel cup holders.



    E232346
  1. Remove the clip and 2 bolts <A>.

  1. Disengage the 2 clips and claw, and remove the front console box.



6. REMOVE VOLTAGE INVERTER ASSEMBLY (w/Voltage Inverter)


    E211999
  1. Remove the bolt.

  1. Disconnect the 2 connectors and disengage the 2 wire harness clamps.



    E212000
  1. Remove the 4 bolts and voltage inverter assembly.



7. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


F050833
  1. Disconnect the transmission control cable assembly from the shift lever assembly.

  1. Remove the clip and disconnect the transmission control cable.



    F050834
  1. Remove the 2 nuts and disconnect the transmission control cable assembly from the body.



    F050835
  1. Remove the nut and disconnect the transmission control cable assembly from the body.



    F050822
  1. Remove the clip and transmission control cable bracket.

  1. Remove the nut and transmission control cable assembly.