Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY


D027751E01
  1. Install the park/neutral position switch onto the manual valve lever shaft and provisionally tighten the adjusting bolt.



    D025795E09
  1. Install the grommet, a new lock washer and the nut.

    Torque:
    6.9 N*m{ 70 kgf*cm , 61 in.*lbf }

  1. Install the manual valve lever shaft onto the groove and turn it 2 notches counterclockwise to the neutral position.

  1. Align the neutral basic line with the switch groove and tighten the adjusting bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. Bend the tabs of the lock washer.

    HINT:
    Bend at least 2 of the lock washer tabs.



2. CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR


3. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
  1. Apply the parking brake and turn the ignition switch to ON.

  1. Depress the brake pedal and check that the engine starts only when the shift lever is set in the N or P position and that it does not start in any other positions.

  1. Check that the back-up light comes on and the reverse warning buzzer sounds only when the shift lever is set in the R position and not in other positions.
    If any failure is found, check the park/neutral position switch for continuity.



4. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


D025795E08
  1. Loosen the bolt of the park/neutral position switch and set the shift lever to the N position.

  1. Align the groove and the neutral basic line.

  1. Hold the switch in position and tighten the bolt.

    Torque:
    13 N*m{ 130 kgf*cm , 9 ft.*lbf }

  1. After making an adjustment, perform the inspection described in step 1.



5. ADJUST SHIFT LEVER POSITION


D028682E02
  1. Push the control shaft fully rearward.

  1. Turn the control shaft lever 2 notches counterclockwise to the N position.

  1. Set the shift lever to the N position.



6. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from the P to R position, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when shifting the lever to the R position.