Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › FLOOR SHIFT ASSEMBLY

FLOOR SHIFT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FLOOR SHIFT ASSEMBLY


F051622
  1. Install the floor shift with the 4 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the 2 clamps and 2 connectors.



2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


F050833
  1. CABLE TYPE:

    1. Connect the transmission control cable with the clip to floor shift assembly.

    2. Install the transmission control cable onto the floor shift assembly.



3. INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY


F051629
  1. ROD TYPE:

    1. Install the floor shift gear shifting rod with nut.

      Torque:
      5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



4. INSTALL FRONT CONSOLE BOX
  1. Engage the 2 clips and claw, and install the front console box.

  1. Install the 2 screws <F>.



5. INSTALL INSTRUMENT PANEL CUP HOLDER TRAY
  1. Engage the 2 clips and 4 claws, and install the instrument panel cup holder tray.

  1. Install the 2 instrument panel cup holders.



6. INSTALL REAR CONSOLE BOX ASSEMBLY


    B290408
  1. Engage the 4 claws and install the console box rear.

  1. Install the 2 screws <F> and 2 bolts <B>.

  1. Install the console box carpet.



7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B290409
  1. Engage the 6 clips and claw, and install the console upper rear panel.

  1. Install the shift knob.



8. ADJUST SHIFT LEVER POSITION


D028682E02
  1. Push the control shaft fully rearward.

  1. Turn the control shaft lever 2 notches counterclockwise to the N position.

  1. Set the shift lever to the N position.



9. INSPECT SHIFT LEVER POSITION
  1. Check that the shift lever moves smoothly and appropriately from the P to R position, only when the ignition switch is turned to ON and the brake pedal is depressed.

  1. When starting the engine, make sure that the vehicle moves forward when shifting the lever from the N to D position and moves rearward when shifting the lever to the R position.