Home › TRANSMISSION ยท A750F AUTOMATIC TRANSMISSION › TRANSMISSION WIRE

TRANSMISSION WIRE > REMOVAL

for Preparation Click here


CAUTION:
When working with FIPG material, you must observe the following guidelines.

  1. Using a razor blade and gasket scraper, remove all the old FIPG material from the gasket surfaces.
  2. Thoroughly clean all components to remove all loose material.
  3. Clean both sealing surfaces with a non-residue solvent.
  4. Apply FIPG in an approximately 1 mm (0.04 in.) wide bead along the sealing surface.
  5. Parts must be assembled within 10 minutes of application. Otherwise, the FIPG material must be removed and reapplied.


1. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug, gasket and drain ATF.

  1. Install a new gasket and drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


F051848

NOTICE:
Some fluid will remain in the oil pan.

  1. Remove the 20 bolts, gasket and oil pan sub-assembly.



    AT00103
  1. Examine the particles in the pan.

    1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.
      Steel (magnetic) ... bearing, gear and clutch plate wear
      Brass (non-magnetic) ... bushing wear



3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


D028692
  1. Remove the 4 bolts, oil strainer and O-ring.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.



4. SEPARATE TRANSMISSION WIRE


D028693
  1. Remove the bolt and clamp.

  1. Disconnect the ATF temperature sensor.

  1. Disconnect the 7 connectors from the solenoid valves.



5. REMOVE TRANSMISSION WIRE


D028008
  1. Disconnect the transmission wire connector.

  1. Remove the bolt and pull out the transmission wire.