PROPELLER SHAFT ASSEMBLY (for Regular Cab 4WD) > DISASSEMBLY |
| 1. INSPECT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING |
Check the spider bearings for wear and damage.
Check each spider bearing's axial play by turning the yoke while holding the shaft tightly.
| 2. REMOVE PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING |
![]() |
Place matchmarks on the flange yoke and sleeve yoke.
![]() |
Using a brass bar and a hammer, slightly tap in the spider bearing outer races.
Using needle-nose pliers, remove the 4 snap rings from the grooves.
![]() |
Using SST, push the spider bearing out of the propeller shaft.
![]() |
Clamp the spider bearing outer race in a vise and tap off the propeller shaft with a hammer.
![]() |
Install the 2 removed spider bearing outer races onto the spider, and clamp them in a vise.
Using SST, push the bearing out of the yoke.
![]() |
Clamp the outer bearing race in a vise and tap off the flange yoke with a hammer.
Remove the spider.