Home › BODY ELECTRICAL › AUDIO / VISUAL › FRONT DOOR SPEAKER (for Regular Cab)

FRONT DOOR SPEAKER (for Regular Cab) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY


    B088112
  1. Pull out the snap ring with a cloth as shown in the illustration, then remove the door window regulator handle assembly.



    B088113
  1. Remove the window regulator handle plate.



3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B088092E01
  1. Disengage the 3 clips and remove the front door lower frame bracket garnish LH.

    NOTICE:
    Confirm that no clips remain on the door panel when the garnish is removed. Transfer any remaining clips to the garnish side before installing.



4. REMOVE FRONT DOOR TRIM PANEL ASSEMBLY LH


B088405E01
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088096
  1. Remove the 2 screws.



    B088097E01
  1. Disengage the 10 clips and remove the front door trim panel assembly LH.



5. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


E075952E01
  1. Disconnect the connector.

  1. Remove the 3 screws and the front No. 1 speaker assembly.



6. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY


    E075954E01
  1. Disconnect the connector.

  1. Remove the 2 bolts.



    E075955
  1. Disengage the claw and remove the front No. 2 speaker assembly.