Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA POLE

RADIO ANTENNA POLE > INSTALLATION

for Preparation Click here



1. INSTALL PULL TOP ANTENNA POLE SUB - ASSEMBLY


    E232552
  1. Install the pull top antenna pole sub-assembly by hand until fully seated.

  1. Using an 8 mm (5/16 inch) wrench, fully tighten the antenna pole about 1/8 turn (20 to 45 degrees) by turning it clockwise.

    HINT:
    1. Do not overtighten. Tighten with finger, not hand.
    2. Do not use pliers to tighten the antenna pole as it can leave marks on the antenna pole surface.
    3. The antenna pole cannot be hand tightened to the proper specification.

    Torque:
    3.3 N*m{ 34 kgf*cm , 29 in.*lbf }