Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA HOLDER

RADIO ANTENNA HOLDER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    E232350
  1. Disengage the claw and separate the glove compartment door stopper from the glove compartment door assembly.

  1. Slightly deform the upper part of the glove compartment door assembly to release the 2 stoppers and open the glove compartment door assembly until it becomes horizontal.



    E232351
  1. Pull the glove compartment door assembly toward the rear of the vehicle to release the 3 hinges and remove the glove compartment door assembly.

  1. Remove the glove compartment door stopper.



3. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH


    E232352
  1. Remove the bolt <B>.

  1. Disengage the 2 clips and remove the instrument panel lower finish panel sub-assembly RH.



4. REMOVE ASSIST GRIP SUB-ASSEMBLY

HINT:
Follow the same procedures as for the opposite side.



    B087422E03
  1. Using a screwdriver with its tip taped in protective tape, disengage the 2 claws and open the cover.
    Text in Illustration 
    *1
    Protective Tape



    B087423E01
  1. Remove the 2 screws and assist grip.



5. REMOVE FRONT PILLAR GARNISH RH

HINT:
Follow the same procedures as for the front pillar garnish LH.



6. REMOVE PULL TOP ANTENNA POLE SUB - ASSEMBLY


    E232551
  1. Using an 8 mm (5/16 inch) wrench, remove the pull top antenna pole sub-assembly by turning it counterclockwise.



7. REMOVE ANTENNA ORNAMENT


E075968
  1. Remove the nut and the antenna ornament.



8. REMOVE WITH HOLDER ANTENNA ASSEMBLY


E075967E01
  1. Disconnect the connector and remove the 3 clamps.



    I030433E02
  1. Tie a piece of string to the tip of the cable of the with holder antenna assembly.

    HINT:
    Use a string that is longer than the antenna assembly (with holder).



    E075969
  1. Remove the bolt and the with holder antenna assembly.

    NOTICE:
    Leave the string inside the pillar for the installation of a new antenna.