Home › BODY ELECTRICAL › AUDIO / VISUAL › AMPLIFIER BOX SPEAKER ASSEMBLY (for Double Cab)

AMPLIFIER BOX SPEAKER ASSEMBLY (for Double Cab) > INSTALLATION

for Preparation Click here



1. INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY


E075992
  1. Using a "TORX" socket wrench T20, install the 4 screws and the stereo component amplifier assembly.



2. INSTALL NO. 1 SPEAKER ASSEMBLY WITH BOX


E075991E01
  1. Install the No. 1 speaker assembly with box with the 4 bolts.

    Torque:
    8.4 N*m{ 85 kgf*cm , 74 in.*lbf }

    NOTICE:
    Install the bolts in the order shown in the illustration.



    E075990E01
  1. Connect the connector.

  1. Install the clamp.



3. INSTALL LUGGAGE COMPARTMENT SIDE TRAY
  1. w/ Woofer:

    1. Engage the 5 claws and 7 clips, and install the luggage compartment side tray.

    2. Tighten the bolt.

  1. w/o Woofer:

    1. Engage the 5 claws and 5 clips, and install the luggage compartment side tray.

    2. Tighten the 3 bolts.



4. INSTALL REAR SEATBACK ASSEMBLY LH


    B087195E01
  1. Install the rear seat back with the 2 bolts.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



5. INSTALL REAR SEATBACK ASSEMBLY RH


    B087217
  1. Install the rear seat back with the 2 bolts.

    Torque:
    37 N*m{ 375 kgf*cm , 27 ft.*lbf }



    B087239E03
  1. Install the rear seat belt inner and rear seat belt outer center of the floor anchor with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }

    NOTICE:
    1. Make sure that the rear seat inner belt and floor anchor of the rear center seat outer belt are oriented in the correct direction when installing.
    2. Be careful not to place the rear seat inner belt (and floor anchor of the rear center seat outer belt) over the convex areas of the floor panel.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }