Home › BODY › ENGINE HOOD / DOOR › HOOD

HOOD > ADJUSTMENT

for Preparation Click here


B057104E08

HINT:
  1. Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the standard bolts (with washers) for the centering bolts when making adjustments.
  2. For bolts without torque specifications, check the standard bolt chart (Click here).



1. INSPECT HOOD SUB-ASSEMBLY



E212004E01

  1. Check that the clearance measurements of areas A through D are within each standard range.

    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    3.5 to 6.5 mm (0.138 to 0.256 in.)
    C
    2.6 to 5.6 mm (0.102 to 0.220 in.)
    B
    4.4 to 7.4 mm (0.173 to 0.291 in.)
    D
    -1.2 to 1.8 mm (-0.047 to 0.071 in.)



2. ADJUST HOOD SUB-ASSEMBLY


    B088159
  1. Adjust the hood position.

    1. Loosen the 4 hinge bolts on the hood side.

    2. Move the hood to adjust the clearance to within the standard range (Step 1).

    3. Tighten the 4 hood side hinge bolts after the adjustment.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    B088160
  1. Adjust the cushion rubber so that the heights of the hood and the fender are aligned.

    1. Raise or lower the hood front end by turning the cushion rubber. Make sure that the clearance is within the standard range.

      HINT:
      Raise or lower the cushion rubber by turning it.



    B278632
  1. Adjust the hood lock.

    1. Remove the 2 bolts and No. 2 hood lock release lever protector.



    2. B278633
    3. Loosen the 3 bolts.



    4. B278634
    5. Adjust the hood lock position so that the striker can enter it smoothly.



    6. B278633
    7. Tighten the 3 bolts after the adjustment.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



    8. B278632
    9. Install the No. 2 hood lock release lever protector.

      Torque:
      8.0 N*m{ 82 kgf*cm , 71 in.*lbf }