REAR DOOR (for Access Cab) > ADJUSTMENT |
![]() |
| 1. INSPECT ACCESS PANEL SUB-ASSEMBLY LH |
Check that the clearance measurements of areas A to F are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 6.0 +- 1.5 mm (0.236 +- 0.059 in.) | D | 6.1 +- 1.5 mm (0.240 +- 0.059 in.) |
| B | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) | E | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) |
| C | 1.8 +- 1.5 mm (0.071 +- 0.059 in.) | F | 2.0 +- 1.5 mm (0.079 +- 0.059 in.) |
| 2. ADJUST ACCESS PANEL SUB-ASSEMBLY LH |
Disconnect the cable from the negative battery terminal.
![]() |
Loosen the body side hinge bolts and adjust the door position.
Tighten the body side hinge bolts after the adjustment.
![]() |
Loosen the door side hinge bolts and adjust the door position.
Tighten the door side hinge bolts after the adjustment.
Remove roof side inner garnish cap LH .
Remove roof side inner garnish LH .
![]() |
Adjust the striker position by slightly loosening the striker mounting screws with a torx socket wrench T40 and hitting the striker with a plastic hammer (upper side).
Using a torx socket wrench T40, tighten the striker mounting screws after the adjustment.
![]() |
Adjust the striker position by slightly loosening the striker mounting screws with a torx socket wrench T40 and hitting the striker with a plastic hammer (lower side).
Using a torx socket wrench T40, tighten the striker mounting screws after the adjustment.
Connect the cable to the negative battery terminal.
Inspect the SRS warning light (Click here).
Install the roof side inner garnish LH .
Install the roof side inner garnish cap LH .