Home › BODY › ENGINE HOOD / DOOR › REAR DOOR (for Access Cab)

REAR DOOR (for Access Cab) > DISASSEMBLY

for Preparation Click here



1. REMOVE ACCESS PANEL REAR WEATHERSTRIP LH


B088050
  1. Remove the access panel rear weatherstrip LH.



2. REMOVE LAP BELT OUTER ANCHOR COVER


B088402E01
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


B088403
  1. Remove the bolt and separate the outer front seat belt assembly LH (floor side).



    B088051E02
  1. Using a screwdriver with its tip wrapped in protective tape, open the cover.



    B088052
  1. Remove the screw, and then remove the access panel inside handle bezel LH.



    B088053
  1. Remove the screw, and then remove the door pull handle.



    B205572
  1. Remove the 10 clips.

  1. Remove the rear door trim board sub-assembly by sliding it upward.



4. REMOVE ACCESS PANEL INSIDE HANDLE SUB-ASSEMBLY LH


B088055E01
  1. Disconnect the rod.

  1. Remove the 3 screws, and then remove the access panel inside handle sub-assembly.



5. REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH


    B087290E03
  1. Remove the nut and shoulder anchor.



    B087291E01
  1. Disconnect the pretensioner connector as shown in the illustration.

  1. Remove the 2 bolts and retractor.



6. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B087292E01
  1. Remove the bolt.

  1. Disengage the 2 claws and remove the front shoulder belt anchor adjuster.



7. REMOVE NO. 1 DOOR TRIM BRACKET RH


B088056
  1. Remove the 2 screws and remove the No. 1 door trim bracket.



8. REMOVE ACCESS PANEL UPPER LOCK ASSEMBLY LH


B088057E01
  1. Disconnect the connector, the connector clamp and the access lock control cable sub-assembly.



    B088058
  1. Remove the 3 bolts, and then remove the access panel upper lock assembly LH.



9. REMOVE ACCESS PANEL LOWER LOCK ASSEMBLY LH


B088059
  1. Using a "TORX" socket wrench T30, remove the 3 screws.



    B088060E01
  1. Disconnect the connector and the access lock control cable sub-assembly.

  1. Remove the access panel lower lock assembly LH by sliding it upward.



10. REMOVE ACCESS PANEL LOCK REMOTE CONTROL ASSEMBLY LH


B088061E01
  1. Disconnect the rod.

  1. Remove the 2 bolts and the screw, and then remove the access panel lock remote control assembly LH.



11. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH


B088062
  1. Using a "TORX" socket wrench T25, remove the 2 screws, then remove the access panel lock cancel lever assembly LH.



12. REMOVE FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY


B088063E01
  1. Disconnect the connector.

  1. Remove the bolt, and then remove the front door courtesy light switch.



13. REMOVE FRONT DOOR LOCK STRIKER PLATE ASSEMBLY


B088064
  1. Using a "TORX" socket wrench T40, remove the 2 screws and door lock striker plate assembly.



14. REMOVE REAR DOOR SERVICE HOLE COVER LH


B088065
  1. Remove the rear door service hole cover LH.



15. REMOVE REAR DOOR CHECK ASSEMBLY LH


B088066
  1. Remove the bolt and 2 nuts, and then remove the access panel check assembly LH.



16. REMOVE REAR DOOR WEATHERSTRIP LH


B088067E01
  1. Disengage the 3 clips.



    B088068E01
  1. Using a clip remover, disengage the 20 clips, and then remove the rear door weatherstrip LH.

    NOTICE:
    Remove the remaining tape on the door side.