REAR DOOR (for Double Cab) > ADJUSTMENT |
![]() |
| 1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH |
Check that the clearance measurements of areas A to F are within the standard ranges.

| Area | Measurement | Area | Measurement |
| A | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) | D | 4.5 +- 1.5 mm (0.177 +- 0.059 in.) |
| B | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) | E | 5.0 +- 1.5 mm (0.197 +- 0.059 in.) |
| C | 1.8 +- 1.5 mm (0.071 +- 0.059 in.) | F | 2.0 +- 1.5 mm (0.079 +- 0.059 in.) |
| 2. ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH |
Disconnect the cable from the negative battery terminal.
![]() |
Using SST, adjust the door horizontally and vertically by loosening the body side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
![]() |
Loosen the door side hinge bolts and adjust the door position.
Tighten the door side hinge bolts after the adjustment.
![]() |
Adjust the striker position by slightly loosening the striker mounting screws using a torx socket wrench T40 and hitting the striker with a plastic hammer.
Using a torx socket wrench T40 , tighten the striker mounting screws after the adjustment.
Connect the cable to the negative battery terminal.
Inspect the SRS warning lamp (Click here).