Home › BODY › ENGINE HOOD / DOOR › TAIL GATE

TAIL GATE > DISASSEMBLY

for Preparation Click here



1. REMOVE TAIL GATE PROTECTOR RH


B088128
  1. Using a "TORX" socket wrench T30, remove the 7 screws.



    B088129E01
  1. Disengage the 10 claws and remove the tail gate protector RH.



2. REMOVE TAIL GATE SERVICE HOLE COVER


B088130
  1. Using a "TORX" socket wrench T30, remove the 8 screws and tail gate service hole cover.



3. REMOVE TELEVISION CAMERA ASSEMBLY (w/ Rear View Monitor System)


E168709
  1. Remove the 2 bolts and television camera.

  1. Disconnect the connector.



4. REMOVE BACK DOOR HANDLE COVER (w/o Rear View Monitor System)


B236664
  1. Disconnect the connector.

  1. Remove the 2 bolts and back door handle cover.



5. REMOVE TAIL GATE LOCK ASSEMBLY LH


B088131
  1. Disconnect the tail gate link as shown in the illustration.



    B088132E01
  1. Disengage the clip and remove the 2 bolts, and then remove the tail gate lock assembly LH from the tail gate.



6. REMOVE TAIL GATE LOCK ASSEMBLY RH

HINT:
Use the same procedure as described for the LH side.



7. REMOVE TAIL GATE HANDLE ASSEMBLY


B088133E01
  1. Remove the 2 bolts.

  1. Disengage the 2 claws and remove the tail gate handle assembly.



8. REMOVE TAIL GATE LOCK STRIKER


B088134
  1. Remove the 2 bolts and tail gate lock striker.

    HINT:
    Use the same procedures for both the LH and RH sides.



9. REMOVE TAIL GATE
  1. Disconnect the connector.



    B088135
  1. Disconnect the tail gate stay.

    HINT:
    Use the same procedures for both the LH and RH sides.



    B088137E01
  1. Remove the tail gate from the vehicle as shown in the illustration.

    NOTICE:
    Be careful not to drop the tail gate.

    HINT:
    Remove the tail gate from the vehicle by lifting up the right side and sliding it slightly to the right.



10. REMOVE TAIL GATE STAY STOPPER


B088136
  1. Using a "TORX" socket wrench T40, remove the screw and tail gate stopper.

    HINT:
    Use the same procedure for both the LH and RH sides.



11. REMOVE TAIL GATE STAY ASSEMBLY


B088138
  1. Using a "TORX" socket wrench T40, remove the screw, washer and tail gate stay assembly.

    HINT:
    Use the same procedure for both the LH and RH sides.



12. REMOVE TAIL GATE HINGE ASSEMBLY LH


B088139
  1. Using a "TORX" socket wrench T40, remove the bolt, 2 screws and tail gate hinge assembly LH.



13. REMOVE TAIL GATE HINGE ASSEMBLY RH

HINT:
Use the same procedure for both the LH and RH sides.