Home › DRIVE LINE › DRIVE SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 4WD)

FRONT DRIVE SHAFT ASSEMBLY (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. DRAIN DIFFERENTIAL OIL


3. SEPARATE FRONT SPEED SENSOR


F052163E03
  1. Remove the bolt and separate the front speed sensor.

  1. Disengage the 2 clamps.

  1. Remove the bolt and separate the speed sensor wire harness from the steering knuckle.



4. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.



    F051679E01
  1. Using SST, separate the tie rod end sub-assembly from the steering knuckle.

    SST
    09628-62011  



5. REMOVE FRONT AXLE HUB NUT


F042729
  1. Using a screwdriver and a hammer, remove the front axle hub grease cap.



    F042732
  1. Remove the cotter pin and adjusting cap.

  1. Remove the front axle hub nut.



6. SEPARATE FRONT SUSPENSION LOWER ARM


G020159
  1. Remove the 2 bolts and separate the front lower ball joint attachment from the steering knuckle.



7. REMOVE FRONT DRIVE SHAFT


F042739E01
  1. Using SST, remove the front drive shaft.

    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    Be careful not to damage the oil seal.