FRONT AXLE HUB (for 2WD) > DISASSEMBLY |
| 1. REMOVE KNUCKLE GREASE RETAINER CAP |
![]() |
Using a screwdriver and a hammer, tap out the knuckle grease retainer cap.
| 2. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, loosen the staked part of the lock nut.
![]() |
Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.
Using a socket wrench (36 mm), remove the lock nut.
Remove the spacer.
| 3. REMOVE STEERING KNUCKLE |
![]() |
Remove the 3 bolts and shift the dust cover towards the hub side (outside).
Using SST, remove the steering knuckle.
Remove the dust cover from the axle hub.
| 4. REMOVE FRONT AXLE HUB OIL SEAL |
Using a screwdriver, pry out the oil seal from the steering knuckle.
| 5. REMOVE FRONT AXLE HUB INNER BEARING |
![]() |
Using snap ring pliers, remove the snap ring.
Using SST and a press, press the bearing out of the steering knuckle.