FRONT AXLE HUB (for 2WD) > REASSEMBLY |
| 1. INSTALL FRONT AXLE HUB INNER BEARING |
![]() |
Using SST and a press, press a new bearing into the steering knuckle.
Using snap ring pliers, install a new snap ring.
| 2. INSTALL FRONT AXLE HUB OIL SEAL |
![]() |
Using SST and a plastic-faced hammer, tap in a new oil seal.
Coat MP grease to the oil seal lip.
| 3. INSTALL STEERING KNUCKLE |
![]() |
Install the dust cover onto the steering knuckle with the 3 bolts.
Using SST and a press, press in the axle hub to the steering knuckle.
| 4. INSTALL FRONT AXLE HUB NUT |
![]() |
Attach the 3 bolts onto the hub bolt in the position shown in the illustration, and screw them into the flange, then fix them in a vice.
Install the spacer.
Using a socket wrench (36 mm), install a new lock nut onto the axle hub.
Using a chisel and hammer, stake the lock nut.
| 5. INSTALL KNUCKLE GREASE RETAINER CAP |
![]() |
Using a brass bar and hammer, install the knuckle grease retainer cap.