FRONT AXLE HUB (for 4WD and Pre-Runner) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WHEEL |
| 3. DRAIN BRAKE FLUID |
| 4. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and separate the speed sensor front LH.
Disengage the 2 clamps.
Remove the bolt and separate the speed sensor wire harness from the steering knuckle.
| 5. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the bolt and separate the brake tube bracket from the steering knuckle.
![]() |
Using a union nut wrench, disconnect the brake tube from the disc brake cylinder.
![]() |
Remove the 2 bolts and disc brake caliper.
| 6. REMOVE FRONT DISC |
| 7. REMOVE FRONT AXLE HUB GREASE CAP (for 4WD) |
![]() |
Using a screwdriver and a hammer, remove the front axle hub grease cap.
| 8. REMOVE FRONT AXLE HUB NUT (for 4WD) |
![]() |
Remove the cotter pin and lock cap.
Remove the front axle hub nut.
| 9. SEPARATE FRONT STABILIZER LINK ASSEMBLY |
![]() |
Remove the nut and separate the stabilizer link from the steering knuckle.
| 10. SEPARATE TIE ROD END SUB-ASSEMBLY |
![]() |
Remove the cotter pin and nut.
Using SST, separate the tie rod end from the steering knuckle.
| 11. REMOVE FRONT SUSPENSION LOWER ARM |
![]() |
Remove the 2 bolts, and separate the front suspension lower arm from the front axle.
| 12. SEPARATE FRONT SUSPENSION UPPER ARM |
![]() |
Support the front suspension lower arm with a jack.
Remove the clip and nut.
Using SST, separate the steering knuckle from the front suspension upper arm.
| 13. REMOVE FRONT AXLE HUB |
for 4WD:
Using a plastic hammer, separate the front axle hub from the front drive shaft.
Remove the front axle hub.