REAR AXLE SHAFT > DISASSEMBLY |
| 1. REMOVE REAR AXLE SHAFT SNAP RING |
![]() |
Using a snap ring expander, remove the snap ring.
| 2. REMOVE REAR AXLE SHAFT |
![]() |
Using SST and press, remove the rear axle shaft.
| 3. REMOVE REAR AXLE BEARING RETAINER INNER |
Remove the rear axle bearing retainer inner from the rear axle bearing.
| 4. REMOVE REAR AXLE SHAFT WASHER |
Remove the rear axle shaft washer from the rear axle bearing.
| 5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Attach the 4 nuts to the rear axle housing bolts.
Using a hammer, remove the 4 rear axle housing bolts and rear axle bearing.
| 6. REMOVE REAR AXLE HUB BOLT |
![]() |
for 2WD:
Using SST, remove the 5 hub bolts.
Remove the deflector and deflector gasket from the rear axle shaft.
![]() |
for 4WD and Pre-Runner:
Using SST, remove the 6 hub bolts.
Remove the deflector and deflector gasket from the rear axle shaft.
| 7. REMOVE REAR AXLE BEARING OIL SEAL |
![]() |
Grind the rear axle bearing inner race surface using a grinder, and then chisel them out with a chisel.
Remove the rear axle shaft oil seal from the rear axle shaft.